The GSU-602-208-CT urn heater IS NOW OBSOLETED, and this is a COMPARABLE immersion heater built with a lower watt density to provide a long heater life and dependable performance. Urn heaters can be designed for use in commercial coffee makers, percolators, restaurant buffet tables, sterilizers, autoclaves, steam tables, kettles, and humidifiers. These immersion heaters are ideal for other applications that require a low profile and short tubular element lengths.

This urn heater is made for applications requiring 208-volt power single phase and 6000 watts. In the urn heater diagram that is attached below, the "A" overall heater length dimension is 14.5" (was 13.5 inches), the "B" inside tank height is 2.125" (was 1 inch), and the "C" width dimension is 4" (was 4 inches). This heater comes with two copper (was stainless steel) sheath tubular elements that are silver brazed into a brass header. This heater is also supplied with a standard 4-inch square or octagon conduit box. The heater needs a minimum 2-7/16" (was 2-3/8 inch) diameter hole for installation. Be sure to compare this heater with the original Glenn Electric heater, because the heater can only be returned if it doesn?t work per the intended purpose and due to a manufacturing defect.
The Glenn Electric immersion heater part number is GSU-602-208-CO or 10-8345-06.

An optional thermal cut-off is supplied with this immersion heater. This protective mechanism will shut the power off to the heater whenever a low liquid level is detected.

Installing an Urn Heater with a Thermal Cut-Off

MARATHON_GSU-602-CT_SIMILAR - Click here for a comparison of the chromalox replacement heater for the GSU-602-230-CT.

Specification Sheet for Chromalox Urn Heaters TTUH-CO

"""""""""""""""""""""""""""""""""""""""""""""""""""""""""""""""